Installation Guide (Wall Mount)

Installation Guide (FD7903, FD8903)

Note: Prior to installation ensure that the installation environment can support at least 3 times the weight of the camera.

Step 1: Drill pilot holes in the position that you wish the camera to be seated using a 3/16 drill bit.

Step 2: Seat the included drywall mounts in the pilot holes that you drilled.

Step 3: Screw the mount on the drywall mounts with the four screws provided.

Step 4: Place the camera on the wall anchors and attach the camera via the two shorter screws. 

Step 5: Position the camera to the area that you would like to surveil and tighten the single screw at the bottom of the mount to finish securing.

Initial Camera Connection

Note: The FDT camera can be accessed through the web browser on a computer or through the FDT View App on a smart phone or tablet PC. There are two methods, wired and wireless connection, to add IP camera via FDT View App. You can choose either of them:

Connecting Your FDT WiFi Camera Through Wired Connection

Step1: Connect the camera to the power adapter. Wait a moment until the camera restarts.

Step 2: Connect the camera to the router by Ethernet cable.

Step 3: Make sure your smartphone is connected to your wireless router.

Step 4: Run the FDT View APP on your smartphone and follow the setup instructions provided.

Note:: If you have added your IP camera successfully by wired connection, do not add it again by wireless connection.

Connecting Your FDT WiFi Camera Through Wireless Connection

Step 1:  Make the antenna upright.

Step 2: Connect the camera with power adapter. Wait a moment until the camera restarts.

Step 3: Make sure your smartphone is connected to your wireless router.

Step 4: Run the FDT View APP on your smartphone and follow the setup instructions provided.

Note: Do not connect the camera with router via Ethernet cable.