How to Perform a Factory Reset (FD7904)

How to Perform a Factory Reset (FD7904)

factory reset will return your camera back  to its original system state by erasing all of the information stored on the device in an attempt to restore the device's software to its original manufacturer settings. To perform a factory reset on your camera please refer to the information provided below. 

Step 1: Apply power to your device using the included USB charging cable and locate the reset button on the back of the camera. 


Step 3: Press and hold the reset button. You will hear a "ding" sound. Hold for 15 - 20 seconds and release. 


Note: The camera will have multiple "ding" sounds after reboot is complete indicating the reset is complete. 

The username and password, WiFi, and all other settings will revert back to its original factory settings. The default username and password for your camera is admin. 

Since the settings have been removed you will need to delete and add the camera back into the FDT View app. 

How To Add Your Camera Back Into the FDT View app.

Step 1: Log into the FDT View app and tap on the trash can icon (mceclip0.png) to delete your camera. 


Step 2: Tap on Add Camera.


Step 3: Tap on Cube Camera. Tap Next to continue. 


Step 4: Tap on Setup a new camera.



Step 5: Make sure your camera is still plugged into power. Tap Next to continue.


Step 6: Enter the password for your WiFi network in the Password field. Tap Set to continue. 


Note: Before your tap Set please make sure the volume on your phone is set to maximum and place the phone close to the camera. 

If you hear a ding sound during setup, tap on Yes to continue. 


Wait for the camera to make a proper WiFi connection. Do not press Next, the screen will disappear automatically once a WiFi connection is made. 


Step 7: Tap on your camera located in the Camera List.


Step 8: Give your camera a name then type in the default username and password for your camera. The default username and password will be admin. Tap Next to continue. 


Step 9: Type in a password for your camera. It is recommended to use a password at least 8 characters long and something you can remember. Tap OK when done. 


Step 10: Tap Start Live View to view your camera.


Your FDT camera has now been properly reset and is ready to view.